Grizzly Drill G5783 User Manual

MODEL G5783

8" REVERSIBLE

⁄

ANGLE AIR DRILL

INSTRUCTION SHEET

EYE/EAR INJURY HAZARD!

Wear safety glasses and

hearing protection during

use of this tool!

INJURY HAZARD!

Always disconnect tool from

air to prevent unexpected

operation during service!

DO NOT EXCEED 120 PSI!

Personal injury could

occur.

Figure 1. Model G5783.

Air drill MUST have 3-4 drops of air tool oil directly

dropped into the air fitting before each use as

shown in Figure 2. Keep the head gear lubricated

by pumping a small amount light grease into the

ball cap on the head.

Introduction

Drill in tight places with this ⁄8" reversible angle

drill. Producing up to 1300 RPM, this angle drill

includes a ³⁄8" Jacobs^®chuck and chuck key. The

large paddle switch also makes this drill easy to

use in any position. Requires 90 PSI of air pres-

sure with 7 CFM of compressor capacity.

Inventory

A. Angle Air Drill ............................................. 1

B. Chuck Key.................................................. 1

C. Hex Wrench 3mm ...................................... 1

Operation

Insert your drill bit up to ⁄8" into the chuck and

Figure 2. Lubricating directly into air fitting.

tighten with the chuck key. Change the drill direc-

tion by pushing the reverse valve into the body

then rotate to lock into position. Connect the drill

to your regulated air source. The hex wrench is

included for removing the screw (Ref #55) that

holds the chuck to the spindle.

If you need help with your new pneumatic tool,

call our Tech Support at: (570) 546-9663.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#PC8322 PRINTED IN TAIWAN